High Pressure Touchless
Touchless bus or truck wash systems are designed for irregular shaped vehicles.
High-pressure water jets combined with correct chemical application thoroughly clean
the most difficult-to-reach areas of the vehicle. A touchless truck wash system is ideal for
garbage trucks, tankers, construction vehicles, military vehicles as well as typical tractor-
trailers and buses. A touchless bus wash system is perfect for public transportation
vehicles that encounter dirt from the heavy city traffic on a daily basis.
Model DTHP 12 Maximum Vehicles Height 12 ft.
Model DTHP 14 Maximum Vehicles Height 14 ft.
Stanard Featuers
- 1 x Pre-Rinse & Foamer Arch
- 4 x Electric Eye Actuators
- 13 x Spinner Nozzle Heads (for 12ft vehicles)
- 13 x Spinner Nozzle Heads (for 14ft vehicles)
- 1 x Spinner Arch c/w
- 1 x 50 HP Pump/Tank Assembly
- 1 x Hydrominder/Chemical Pump/Foamer Station Assembly
- 1 x 55ft Fixed Guide Rails c/w Epoxy Anchors
- 1 x MCC c/w PLC base controls
- 1 x Pneumatic Panels
- 1 x Utility Racks
- 1 x 2" Water Make Up Solenoid
- 1 x Entrance Signal
Options
- Two step chemical application arch
- Chasis wash
- Wheel wash
- Water Reclaim
- Blower/Dryer
- Stainless Steel skid plates
- Auto door control
- Splash curtains
- Water Softener
- Water Heater
Main Service Requirements
- Electrical AT220V AT 460V AT 575V
- Add For High Pressure Spinners (50HP) - 200A 100A 80A
- Add For Wash Water Recycle System (two x 7.5hp) - 50A 25A 20A
- Compressed Air .5" Air Line at 80 PSI
- Water 2" Minimum Cold Water Line at 50PSI (Drain and Sewage Per Local Codes)
A touchless truck wash system is a perfect easy-to-use solution for vehicles that are typically hard to clean. For more information or to get your touchless bus wash system set up, give Pseco a call.